|
| |
BENDER Medical Products
Digital Clocks/Elapsed Timers
ZT1490
- UL recognized
- Overload protection with automatic reset
- Microprocessor design with special quartz timing circuitry for ultimate
stability and repeatability
- No harness between PC boards, potential for maintenance at board level
- Power outage backup for at least 24 hours, no batteries
- Protected against HF interference and transient voltages
- Code blue output
- Serial bus RS485, with a twisted pair shielded cable
- Up to 32 Clock/Elapsed Timer (ZT1490/1491) and/or Surgical Chronometer
(ZT1494) can be connected in a Master/Slave arrangement, via approximately
3200 feet of cable
Link to:
ZT1490
Data Sheet (PDF)
ZT1491
- UL recognized
- Overload protection with automatic reset
- Microprocessor design with special quartz timing circuitry for ultimate
stability and repeatability
- No harness between PC boards, potential for maintenance at board level
- Power outage backup for at least 24 hours, no batteries
- Protected against HF interference and transient voltages
- Code blue output
- Serial bus RS485, with a twisted pair shielded cable
- Up to 32 Clock/Elapsed Timer (ZT1490/1491) and/or Surgical Chronometer
(ZT1494) can be connected in a Master/Slave arrangement, via approximately
3200 feet of cable
Link to:
ZT1491
Data Sheet (PDF)
Surgical Chronometer
ZT1494
- UL recognized
- Overload protection with automatic reset
- Microprocessor design with special quartz timing circuitry for ultimate
stability and repeatability
- No harness between PC boards, potential for maintenance at board level
- Power outage backup for at least 24 hours, no batteries
- Protected against HF interference and transient voltages
- Code blue output
- Serial bus RS485, with a twisted pair shielded cable
- Up to 32 Clock/Elapsed Timer (ZT1490/1491) and/or Surgical Chronometer
(ZT1494) can be connected in a Master/Slave arrangement, via approximately
3200 feet of cable
Link to:
ZT1494
Data Sheet (PDF)
Clock/Elapsed Timer Remote Controls
MK1450-G1
MK1450C-G1 MK1450T-G1
- No interference with medical equipment
- Interfaces with all BENDER Clocks/Elapsed Timers, ZT1490 and ZT1491
- Uses low voltage wiring (5V DC)
- Mounts to standard electrical gang box
- Connection is by screw terminal strip
- Easy to clean rugged stainless steel
Link to:
MK1450
Data Sheet (PDF)
Remote Control for Surgical Chronometer
MK1454-G4
- No interference with medical equipment
- Interfaces with all BENDER Clocks/Elapsed Timers, ZT1490, ZT1491, and
ZT1494
- Uses low voltage wiring (5V DC)
- Mounts to standard electrical gang box
- Connection is by screw terminal strip
- Easy to clean rugged stainless steel
Link to:
MK1454
Data Sheet (PDF)
Specifications and other data subject to change without notice.
For more information on BENDER Medical Products, please visit
http://www.bendermedical.org
|
